S&E Software Help Center

The Abaqus interface in FEM Builder does not output hyperelastic materials unless the non-linear geometry check box has been selected. So, to get hyperelas...

FEM Builder stores Hero results, including the grid state (think nodes and elements), for each time step. Right now, the position of the nodes at each time...

There is a know issue with check boxes in grid controls not being visible if certain Windows settings are used.  Here is a list of what setting that caus...

In addition to having the ability to read and write NX files from within FEM Builder, the FEM Builder NX Plugin adds the ability to read and write FEM Buil...

To read ODB files from Abaqus, Fem Builder uses the Abaqus ODB libraries.  These libraries are distributed with a standard installation of Abaqus.  However...

This question has perplexed scientist and engineer alike.  What exactly is the best way to look at my data?  The answer is a resounding "it depends on ...

FemBuilder will produce a message regarding Application Dlls that states" Failed to load Hero application DLL. Hierarachic results may not be accur...

The coordinate system used by FEM Builder is the same used by most analysis programs.  Interpretation of coordinates depends on the element being referenced...

There are two options in FEM Builder that control the way graphics are drawn: Microsoft GDI and OpenGL.  The Microsoft GDI driver uses older technology to d...

The FEM Builder interface to NX currently supports NX 12.0.  Older versions of FEM Builder support older versions of NX as follows:   FEM Builder 2019-08...